Adjust or turn off groups of timers in less than a minute from your desk.

Ware Brothers' Controllers can update each other over a network or the Internet.  For example, if you set the watering percentage to "0" for 24 hours on one timer, you can set other timers to update themselves from the first timer.  Using this option, it is easy to turn off or reduce the watering level for large groups of timers in less than a minute!  Compare that with the cost of sending an employee to each location when a temporary adjustment is needed!

Designate no water times for each timer.

Set times during the day when no watering will take place, regardless of the schedule.  This is perfect for parks or other properties that are in use at certain times each day.

Water only as much as is needed and only in the right environmental conditions.

Each timer has 8 sensor input terminals.  Select which sensors each station will respond to.  For example, with a moisture sensor, you can set a station to water until the sensor indicates there is enough water.  The station will "follow" the sensor.  Use rain sensors to temporarily shut down certain stations, wind sensors to delay watering, and so on.

Access controllers from any computer connected to a network or the Internet.

Each timer can have its own network or Internet address.  There is no software to install on your computer.  It is all contained on the timer in the form of a web page.   Program the timer with your computer, disconnect it from the computer and let it operate as a stand-alone timer, or leave it connected for constant access.